The GREPLAY Procedure

PREVIEW Statement

Displays the panel outlines for one or more templates using the current device. Use the TC statement to specify the template catalog before using the PREVIEW statement.

Tip: When you preview a list of templates, press END or ENTER to preview the next template in the list.

Note: The graphics output produced when you preview a template is stored in a catalog named WORK.GTEM, which is deleted at the end of your session.

Syntax

PREVIEW template-entry(s) | _ALL_ ;

Required Arguments

One of the following is required:

template-entry(s): identifies one or more template entries that are contained in the current template catalog. You can preview one entry or a list of entries with one PREVIEW statement.
_ALL_: previews all of the templates in the current template catalog.

Chapter Contents
Previous
Next
Top of Page

Tip:	When you preview a list of templates, press END or ENTER to preview the next template in the list.
Note:	The graphics output produced when you preview a template is stored in a catalog named WORK.GTEM, which is deleted at the end of your session.