- General safety
- Research safety
- Construction safety
- Safety committees
Laboratory safety programs apply across many, if not all, campus laboratories. They are developed to ensure the health and safety of university members and to ensure legislatorial compliance. The programs also serve to set out university's program-specific requirements as well as to support education and training. The SFU Laboratory Safety Manual contains a comprehensive review of the SFU Laboratory Safety Program.
Most laboratory buildings experience occasional brief periods of power loss. Power outages can be unpredictable in duration and timing. These instances may be minor disturbances or could damage equipment or ruin experimentation. Longer term power outages may cause significant disruption and loss. It is important to consider the effects of long-term and short-term power loss and implement plans to minimize negative outcomes.
Each laboratory should develop a plan to protect laboratory equipment, materials, and research from loss and to prevent hazardous conditions from developing during a power outage.
EHS has created a Laboratory Power Outages Guide and a Laboratory Power Outages Infosheet, that enable faculty, staff, researchers and students that work in laboratories with hazardous materials and equipment, to prepare when a planned or unplanned power outage impacts laboratory operation. These documents suggest actions to take before, during and after a power outage.
When a hazardous material spill occurs, you must conduct an initial risk assessment to determine if:
- it is safe to clean up on your own,
- you require assistance/resources, or
- evacuation is required
University laboratories work with a variety of hazardous materials, each of which may have specific considerations for spill cleanup.
Review the material-specific spill response procedures below.
Minor spills of hazardous materials that present no immediate threat to health or safety can usually be cleaned up by lab workers. As a rough guide, spills of less than 50 mL are normally considered to be minor. If you are ever in doubt, evacuate and call for assistance.
When deciding how to proceed with cleanup of a minor spill, answer the following questions:
- Have you received spill response training?
- Does the lab have a spill response kit specific to the material spilled?
- Have you consulted the Safety Data Sheet for specific procedures or considerations?
- Is there adequate ventilation to prevent exposure to harmful vapours?
- Do you know how to dispose of the contaminated materials?
Major spills of hazardous materials present an immediate threat to health and safety and require additional planning and resources. Depending on the material, a small spill can still be serious and require a coordinated spill response. Always exercise caution.
In the event of a major spill, notify everyone around you and immediately evacuate using the further exit from the spill.
Call Campus Public Safety (778.782.4500) and Environmental Health and Safety for assistance.
If it is necessary to evacuate the entire building, pull the fire alarm and call 911.