Moves the drawing pointer to a specific location without drawing
a line.
- GROUP=group-value
MIDPOINT=midpoint-value
SUBGROUP=subgroup-value
- specify coordinates for HBAR and
VBAR charts from the GCHART procedure. Use these variables only with the
data coordinate systems 1, 2, 7, and 8.
- WHEN='B' | 'A'
- specifies when to perform the move
in relation to other procedure output. See also WHEN Variable.
-
X=horizontal-coordinate
Y=vertical-coordinate
Z=depth-coordinate (PROC G3D
only)
XC='character-type-horizontal-coordinate'
YC='character-type-vertical-coordinate'
- specify the coordinates to which
the pen is to be moved. The Z variable can only be used with the G3D procedure.
- XSYS='coordinate-system'
- specifies the coordinate system for
the X or XC variable. Use the XC variable only with XSYS='2'. See XSYS Variable for an explanation
of coordinate-system.
- YSYS='coordinate-system'
- specifies the coordinate system
for the Y or YC variable. Use the YC variable only with YSYS='2'. See YSYS Variable
for an explanation of coordinate-system.
- ZSYS='coordinate-system'
- specifies the coordinate system for
the Z variable. See ZSYS Variable
for an explanation of coordinate-system.
Use MOVE to prepare for a DRAW command,
a BAR command, or programming functions.
Copyright 1999 by SAS Institute Inc., Cary, NC, USA. All rights reserved.
