Chapter Contents

Previous

Next

TCPPORTLAST=

Valid in:	configuration file, SAS invocation
Category:	Communications: Networking and encryption
PROC OPTIONS GROUP=	COMMUNICATIONS

Syntax Description

n | nK | nM | nG

specifies the last TCP/IP port for SAS/CONNECT to use for a remote operating environment connection in terms of bytes, kilobytes, megabytes, and gigabytes respectively.

MIN

sets the minimum for the last TCP/IP port for SAS/CONNECT to use for a remote operating environment connection to 0.

MAX

sets the minimum for the last TCP/IP port for SAS/CONNECT to use for a remote operating environment connection to 65535.

hex

specifies the last TCP/IP port for SAS/CONNECT to use for a remote operating environment connection as a hexadecimal number. This number must be followed by an X.

Details

To assign the range of ports, assign the first port with the TCPPORTFIRST= system option and the last port with the TCPPORTLAST= system option. To restrict the connection to one port, set these options to the same value. This option is only useful for a SAS/CONNECT remote session.

Operating Environment Information:   Valid values may be specific to a given operating environment. For details, see the SAS documentation for your operating environment or contact your system administrator for information about valid values.  

See Also

	System Option: TCPPORTFIRST=
	Communications Access Methods for SAS/CONNECT and SAS/SHARE Software

Chapter Contents

Previous

Next

Top of Page

Copyright 1999 by SAS Institute Inc., Cary, NC, USA. All rights reserved.